Hudební fórum

Kuliman píše:aha a bez toho se neobejdu že?

Kuliman píše:Mám takovej problém, když to přes redukci zapojím do PC, tak mi to hraje jenom z levé strany, aji když to dám do hi-fi věže, tak hraje jen jeden reprák. Je to tou redukcí? že by tam byl špatnej kontakt? nebo čím?

Slečna Wiki píše:When a three-conductor version of the 1/4″ jack was introduced for use with stereo headphones, it was given a sharper tip profile in order to make it possible to manufacture jacks (sockets) that would accept only stereo plugs, to avoid short-circuiting the right channel amplifier. This attempt has long been abandoned, and now the normal convention is that all plugs fit all sockets of the same size, regardless of whether they are balanced mono, unbalanced mono or stereo. Most 1/4″ plugs, mono or stereo, now have the profile of the original stereo plug, although a few rounded mono plugs are also still produced. The profiles of stereo miniature and subminiature plugs have always been identical to the mono plugs of the same size.

The results of this physical compatibility are:

If a two-conductor plug of the same size is connected to a three-conductor socket, the result is that the ring (right channel) of the socket is grounded. This property is deliberately used in several applications, see "tip ring sleeve", below. However, grounding one channel may also be dangerous to the equipment if the result is to short circuit the output of the right channel amplifier. In any case, any signal from the right channel is naturally lost.

If a three-conductor plug is connected to a two-conductor socket, normally the result is to leave the ring of the plug unconnected (open circuit). In the days of vacuum tubes this was also potentially dangerous to equipment but most solid state devices tolerate this condition well. A 3-conductor socket could be wired as an unbalanced mono socket to ground the ring in this situation, but the more conventional wiring is to leave the ring unconnected, exactly simulating a mono socket.